So - Who's Getting Their Free Tax Stamps This Week?

[ecu1984]

dead Air in box.jpg
In Hard Case.jpg

[USMCsilver]

If it doesn’t suck tomorrow, I’ll probably shoot it and let you know. I think once they plow through some of the initial massive amount of submissions, it will be 24 hours (as long as it’s not your first). Before these, my previous one was 24 hours with the $200. I’d like one more and then I’m done for a while. I’m set up pretty good for a relatively wide range of pistols and rifles with what I’ve accumulated.

Yeah, I miss my fast approvals. But, I've got more than enough to keep me tied over.

I think tomorrow won't be too bad. I know I'll be in and outta the house trying to get my AR9 to properly brrrt. She's being a little bitch.

Sent from Galaxy S25 Ultra using Tapatalk; don't blame me for the phone's mistakes.

[Chessbay]

^^^^Nice ECU, which DA can is that?

This Sandman X was my previous purchase. I run in on that top gun in 6mm ARC and the Lower MR556 as well. Keymo mount on both.

IMG_1289.jpg

[ecu1984]

^^^^Nice ECU, which DA can is that?

This Sandman X was my previous purchase. I run in on that top gun in 6mm ARC and the Lower MR556 as well. Keymo mount on both.

IMG_1289.jpg

Very nice!
It's the Dead Air Mask .22 It's stupid quiet and little to none first round pop
I'm researching what suppressor to get right now for a .300 Blackout SBR
Way too many to choose from.

[USMCsilver]

//pics//

Rick -- leave that hammer cocked whenever that P22 is not in use. You wanna wear down that hammer spring a little so it'll eat lower power ammo; you can even cut a coil or two to help out, without getting light strikes.

Lower MR556 as well.

That HK is sweet! I just can't justify the coin on an AR with HK's name on it...

[ecu1984]

Rick -- leave that hammer cocked whenever that P22 is not in use. You wanna wear down that hammer spring a little so it'll eat lower power ammo; you can even cut a coil or two to help out, without getting light strikes.



That HK is sweet! I just can't justify the coin on an AR with HK's name on it...

Thanks,
Springs already been done and completely polished all internals, slide rails, etc
Super reliable

[Chessbay]

That HK is sweet! I just can't justify the coin on an AR with HK's name on it...

Thanks, the HK is fun.

I am very, very left handed. Those two guns offer the absolute best ambi control options out there. Both have ambi safety, mag release, bolt close and both lock the bolt open on the left and right side. Biggest drivers for me buying them.

[USMCsilver]

Thanks, the HK is fun.

I am very, very left handed. Those two guns offer the absolute best ambi control options out there. Both have ambi safety, mag release, bolt close and both lock the bolt open on the left and right side. Biggest drivers for me buying them.

Thankfully, God made me correctly.

I've considered picking one up, as I do enjoy their quality, but in the back of my head, it'll always just be an AR-15; everyone's always trying to build a better mousetrap. However, in your situation, I totally get it.

Sent from Galaxy S25 Ultra using Tapatalk; don't blame me for the phone's mistakes.

[trkykilr]

Scythe and Mask are my next two.

[SilverFox]

ATF emails were down during that time frame.

Call your FFL. They need to login and see if it's been approved.

Otherwise, no one will ever know.

Or, contact the ATF and get the status.

It should have already been approved.

Sent from Galaxy S25 Ultra using Tapatalk; don't blame me for the phone's mistakes.

I meant to tell you that you were right. Mine was ready in 2 days and locked up in the system some where. If I remember correctly it was sent on 12/13 and approved on 12/15. Thanks again.

[USMCsilver]

I meant to tell you that you were right. Mine was ready in 2 days and locked up in the system some where. If I remember correctly it was sent on 12/13 and approved on 12/15. Thanks again.

Ha. I'm right every now and then! Glad it worked out!

Sent from Galaxy S25 Ultra using Tapatalk; don't blame me for the phone's mistakes.

[Sportin' Woodies]

Tell me more about that 6mm arc

[Steelin' Ducks]

I do have a nice 6mm can.
Dead Air Lazarus. (556 as well)

[Chessbay]

Tell me more about that 6mm arc

The rifle is Radian Model 1 with a 14.5" Pin and Welded Barrel. It has a Keymo muzzle device making it non SBR @ 16". Sub MOA accuracy.

The 6mm ARC is a pretty bad ass round. It is ridiculously fast and very flat shooting.......outperforming both .556 and 308 by a mile. Over 1000FPS beyond 1000 yards.....not that I shoot that far, but you can. It is also way, way less affected by wind.

It has become pretty popular in the AR Platform because it will work in an AR 15 configuration without having to go to an AR10.

It kills shit just fine DRT.

I like Hornady Precision Hunter 103gr ELD-X..........pic is 556 on left and 6 ARC on right.

That DA Lazarus Steelin has would be a perfect CAN for it.


IMG_1405.jpg

IMG_1030.jpg

IMG_1179.jpg

[USMCsilver]

Scythe and Mask are my next two.

There are lots of better options over the Mask (unless you're just dead-set on that).

Sent from Galaxy S25 Ultra using Tapatalk; don't blame me for the phone's mistakes.

[WoodieSC]

There are lots of better options over the Mask (unless you're just dead-set on that).

Sent from Galaxy S25 Ultra using Tapatalk; don't blame me for the phone's mistakes.

I got notice yesterday that my OCL Ti-22 is ready to pick up. Submitted by SS on 1/7/26, cleared 1/27/26.

[USMCsilver]

I got notice yesterday that my OCL Ti-22 is ready to pick up. Submitted by SS on 1/7/26, cleared 1/27/26.

WHOO HOO!!!

You're gonna LOVE it. By far my best outta my five (so far); I'm looking forward to hearing how it compares to my Jesse's Girl (that's currently in jail).

[nitro5x6's]

I'm looking at that can for my rimfire needs...

[gooseaholic]

My 2 Masks were submitted on 1/9 and approved today. Both on trusts.

[bigbuckdown]

Just got my form 4 back in 7 days.


Sent from my iPhone using Tapatalk