PSE String Suppressor

[treesuitsc]

I have a PSE X-Force that has a String Suppressor on it. I have been told that there should be a gap between the string and the suppressor about the width of a credit card. Is this correct? Well if this is the case I have a problem. There are pre-drilled holes for adjustment and none of the holes will allow the suppressor to have this "Credit Card" width. It is either too short (big gap) or too long(actually pushing out on the string)? What should I do? I can make it work by not using the pre-drilled holes but the screws stick out of the rod. I could also add some spacers to the suppressor where it screws into the bow. Anyone out there had this problem?

[quackersncheez]

pse string suppressors have holes on the top and the bottom. turn the piece that slides inside over and it will make a half adjustment...

[wooduck34]

I had the same prob on my x-force, I just put a rubber washer on it.