DC, I'm also gonna point you in the direction of a replacement. I've been doing a lot of stock work these past few years. I've done similar repairs and can make the stock serviceable but you can still see the imperfection, and that's even after a complete strip and refinish which takes a lot of time. Why pay a competent person for their time when you can procure a bolt-on replacement for about the same amount, if not less?
Cole's unloads their take offs on eBay. You can usually find a new set for $200. Any 680-series stock will work.
Case in point- this one is in good shape for less than $180 https://www.ebay.com/itm/18644759220...emis&media=SMS
Btw, I can look at the picture and tell ya that one is not a LH. A stock with proper cast for LH shooter, if you remove the but pad and look at the center hole, it'll have more wood left of the hole. It's opposite for a RH shooter. The logic is it shifts the receiver/barrel in toward shooter's dominant eye. A neutral stock with no cast will have equal amounts of wood on both sides of the hole.
Sent from my SM-G970U using Tapatalk
Last edited by willyworm; 07-06-2024 at 07:16 PM.
[SIGPIC][/SIGPIC]
Delta in a nutshell: Breeding grounds + small wetlands + big blocks of grass cover + predator removal + nesting structures + enough money to do the job= plenty of ducks to keep everyone smiling!
"For those that will fight for it...FREEDOM...has a flavor the protected shall never know."
-L/Cpl Edwin L. "Tim" Craft
Bookmarks