Polaris stuck CV axle

[JOHNSON]

How the **** do you get this done? I’m pretty sure there is no easy way to do it.


Sent from my iPhone using Tapatalk

[Bownut]

Pulling it? Try a slide hammer.

[KRT]

Cut the boot off. Knock the shaft out, go to Harbor Freight and buy you an inexpensive slide hammer and spot weld it to the part stuck in the diff

[b-stick]

Exactly what KRT said.

I fought one for several hours on my ranger.

I cut a piece of plate slightly larger than the OD the axle, threaded it for my slide hammer, tacked it, and second slam of the slide hammer it was out. I don’t even waste my time doing it any other way which I am sure there are easier.

[JOHNSON]

Well…

Ended up with a brake rotor from a f-250 for a slide hammer. It probably took 50 kettle bell swings to get it out. Ten years of rust was not good for me.


Sent from my iPhone using Tapatalk

[JOHNSON]

Cut the boot off. Knock the shaft out, go to Harbor Freight and buy you an inexpensive slide hammer and spot weld it to the part stuck in the diff

Did you get that hauling done?


Sent from my iPhone using Tapatalk

[KRT]

Did you get that hauling done?


Sent from my iPhone using Tapatalk

No. When I went to pay for the product, it mysteriously wasnt available anymore.

[JOHNSON]

No. When I went to pay for the product, it mysteriously wasnt available anymore.

Let me know what you need and I’ll get it taken care of.


Sent from my iPhone using Tapatalk

[2thDoc]

i hate i missed this...

[JOHNSON]

There were many colorful words being thrown out.


Sent from my iPhone using Tapatalk