Specifically, their glue. I have the primer pen and glue, using it on their 2.75 Driver vanes.
The glue is taking a ridiculously long time to dry even to the point I can release the clamps without disturbing the clamp placement. I am priming the vane and have even taken to priming the arrow shaft too, in case that would help. Arrow has been wiped clean with alcohol before any of that.
Planning on calling them tomorrow to see if they may have had a bad batch of glue but have y’all had/heard of any such problems? The bottle says it should be bonded in 5 seconds (as I would expect with any CA glue, especially when using an accelerator like I presume the pen is) and shoot in 15min. I’m about to go check but I doubt they are ready even after 10min or so.
Talk to me….
Bookmarks