3rd shell jams. every time. It doesn't matter shell type..I can usually replicate just unloading it manually (no fire). cleaned the chamber well and oiled.
20200103_092112.jpg
3rd shell jams. every time. It doesn't matter shell type..I can usually replicate just unloading it manually (no fire). cleaned the chamber well and oiled.
20200103_092112.jpg
magazine spring needs cleaning/replacing is where I’d start.
When you pull the magazine spring out stretch it a little before putting it back in
.
80-20 Genaration
Clean the gas ports also
As was mentioned take out the magazine spring and clean the tube. The spring may be rusted. Also remove the trigger group and clean.
If it ain\'t accurate at long distance, then the fact that it is flat shooting is meaningless.
thanks for the replies. I finally made time between duck killing to take it apart. The threaded end of the magazine tube wouldn't come off. I read on a forum to heat it up with a torch first?
Thanks Jack!! not sure why I couldn't remember doing that with my older pumps.
The spring was extremely rusty. I cleaned it well, and then nailed it to the wall while it was stretched out some. After 24hrs put it back in and it now cycles correctly. Thanks all.
Bookmarks