Norway fusion vanes a screwed up

[quack head 11]

Just a heads up for anyone who uses these.

The Norway company is aware of the screwed up vanes and is trying to fix them but that dont mean that a bunch aint on the shelf.

The vanes are curling once you have glued them. You can have enough glue and they look to seal fine when you first fletch them but then they curl and you can take your finger and with just a little pressure pop them right off.

Anyway just thought I would mention it, if you use fusion may wanna give em a looksy

[StrutnBPS]

I've been using them for the past few years and really like them. I'm sure that the company will replace the defective vanes if a customer ends up with any. There was a member on here swearing that they would wrinkle if I used the Helix jig on them, but I have yet to have one do so.

[quack head 11]

Not sure that it matters but the ones giving me the problems are the 3" models.

I just tried to take a picture but I couldn't get the cell to focus on such a small area.

You still slinging the Rage?

[StrutnBPS]

No. Got tired of the dull blades. You would think with all the money they spend on marketing that they would put better quality steel on their heads.

[quack head 11]

What you slinging now?

[StrutnBPS]

Was using Razor Tricks until they got so hard to find this summer. Now Slick Trick mags. So far I've got 4 hogs and an oak tree with the RTs and a deer and hog with the STs.

[surfcock]

Was using Razor Tricks until they got so hard to find this summer. Now Slick Trick mags. So far I've got 4 hogs and an oak tree with the RTs and a deer and hog with the STs.

How far'd that oak go before it fell? Did you get a clean pass through?

[StrutnBPS]

I guess you can say it knocked it in the dirt. LoL