I've got a 2015 Mx 5800. Recently had a guy here in town do a full service on it. He also installed a front facing light bar and two rear facing led pod lights. Last Saturday I mowed for about 3 hours then suddenly the tractor cut off. I tried to crank it back up and it just kept turning over. Waited a few minutes and turned it over and it finally cranked up and the rpm went up and down for about 5 seconds then it cut itself back off. Waited a few minutes and it wouldn't start. Finally it would crank up and it would maybe run 10 seconds or 10 minutes then eventually cut back off. I limped it back to the trailer and carried it back home. I have had an issue in the past with the seat not making full contact with the safety switch underneath. I did zip tie it down. Which I don't like to do but I'm trying to eliminate things.
Fast forward to yesterday. I went to bush hog with it behind my house to test it out. I mowed for a little over an hour and it did great until it cut off again and did the exact same thing. This morning I walked back there to at least try and get it to run long enough to get it back to the house and it only lasted about 30 feet at a time before cutting off.
There is an error code on the dash that reads E-94 which I found out seems to be some type of electrical issue. I'm not sure if this was caused by tapping into the wiring for the light bars or something else un-related. I haven't had the light bars on at all really. It almost feels like a fuel issue. Not sure why it would run for an hour yesterday before giving me problems
Bookmarks