This has probably been covered before, but I couldn’t find anything.
Need a Gunsmith near Chapin for wood/work on an older shotgun.
This has probably been covered before, but I couldn’t find anything.
Need a Gunsmith near Chapin for wood/work on an older shotgun.
There's a few in saluda county
Hancock 70 Yamaha
Check with Maurice. He’s not far. I don’t have his number right off hand but google his name and you can get it.
Barry Hefner in Silverstreet SC. 803-924-2740
There’s one in Little Mountain I have used. I can’t remember the name, maybe someone knows ...
I think Stoudemire is in Little Mountain. Never met them.
I would not recommend Maurice in Saluda at all. Had an experience with him that was pretty bad
Out of curiosity what you looking to have done?
Sent from my SM-G970U using Tapatalk
[SIGPIC][/SIGPIC]
Delta in a nutshell: Breeding grounds + small wetlands + big blocks of grass cover + predator removal + nesting structures + enough money to do the job= plenty of ducks to keep everyone smiling!
"For those that will fight for it...FREEDOM...has a flavor the protected shall never know."
-L/Cpl Edwin L. "Tim" Craft
Nice guy but I took my SX3 to him to get a stuck choke out (obviously my fault) and he ended up cutting the barrel and re-threading. He did so with a Remington tap instead of an Invector so I had to buy all new chokes. That wasn't a huge deal but he didn't let me know before he did it. Then, after cutting the barrel, he drilled and tapped for the front bead but went too deep and apparently put some thread lock on the bead to keep it straight. Discovered this later when it loosened and was cocked to one side. It eventually fell out.
Jerry in little mountain is a damn good gunsmith but I don’t think he does woodwork.
RIP Kelsey "Bigdawg" Cromer
12-26-98 12-1-13
If love could have saved you, you would have lived forever.
Missing you my great friend.
Bookmarks