I pulled the old switches and found that most were corroded and a few prongs had broken off and had to be replaced anyway. I have wired switches before but never using whatever type of wiring this is called. The owner before me had drilled five holes for each of the switches, but didnt take the the time to drill them all in a straight line and my ocd cannot handle it. I found a switch panel that I can instal and will look more clean. Can someone look at my current wiring picture and help me figure out how to wire this switch together? Like I said, i get wiring red wire to positive terminal and black wire to negative, but this doesn’t look as easy. This looks like there is only one prong open on the panel, so how do you connect a positive and negative wire from each accessory to the panel, do you just connect the positive to the panel and then ground the negative to something else?
Switch Panel
https://www.amazon.com/dp/B07KYNK9VC..._kF5qDb81F35XH
Current Wiring
33B8858D-C4E3-4544-86D6-F64662C9747F.jpg
Bookmarks