Does anyone know where to get these or if they are homemade
Does anyone know where to get these or if they are homemade
“My names Thrane Tuck an I don’t give a fuck” - T-bone
It’s usually manual or hydraulic. Either can be bought from a store but you can also make a manual plate yourself.
I’m talking about the ones with the hand pump to pump the motor up higher while going but not electric
“My names Thrane Tuck an I don’t give a fuck” - T-bone
Why in the name of all things holy would you want to be driving a boat and pumping something to raise or lower the motor when you can simply mash a button?
[SIGPIC][/SIGPIC]
Delta in a nutshell: Breeding grounds + small wetlands + big blocks of grass cover + predator removal + nesting structures + enough money to do the job= plenty of ducks to keep everyone smiling!
"For those that will fight for it...FREEDOM...has a flavor the protected shall never know."
-L/Cpl Edwin L. "Tim" Craft
Red Bull Dingy Racing uses manual pump for trim.
Makes sense. I'm sure they sacrifice it for weight.
[SIGPIC][/SIGPIC]
Delta in a nutshell: Breeding grounds + small wetlands + big blocks of grass cover + predator removal + nesting structures + enough money to do the job= plenty of ducks to keep everyone smiling!
"For those that will fight for it...FREEDOM...has a flavor the protected shall never know."
-L/Cpl Edwin L. "Tim" Craft
I know this is very old but there is couple YouTube videos on it. More of a tilt/trim then a Jack plate though, pushes the more out using a hydraulic manual jack, release and it goes back due to the fact your moving forward. Pretty neat though.
New here so I'm reading a bunch of old threads.
Sent from my SM-T350 using Tapatalk
On the fly jack plates has a wheel on theirs you can turn to raise and lower. For smaller outboards only. Kinda pricey though
Bookmarks