Anyone had to replace one?
Can’t get the screws out of the original bracket and can’t get the sheared bracket off the hydraulic arm. Anyone have any tips?
Anyone had to replace one?
Can’t get the screws out of the original bracket and can’t get the sheared bracket off the hydraulic arm. Anyone have any tips?
Sea Ark 1542 w/ Yamaha 40
Xpress 16 w/ 50 Hammer
War Eagle 15 w/ 30 Hammer
--------------------------------------------------
"Sometimes you gotta grab the bull by the horns and the women by the tits and take charge in your life" - General Patton
"I'm very drunk and I intend on getting still drunker before this evening's over."
- Rhett Butler
I've replaced mine a couple times. Broke it again a couple weeks ago, and have to do it again. Use some penetrating oil, and let it sit. You can use some heat on it, but be careful if you do.
The strongest reason for the people to retain the right to keep and bear arms is,
as a last resort, to protect themselves against tyranny in government.
Thomas Jefferson
Sea Ark 1542 w/ Yamaha 40
Xpress 16 w/ 50 Hammer
War Eagle 15 w/ 30 Hammer
--------------------------------------------------
"Sometimes you gotta grab the bull by the horns and the women by the tits and take charge in your life" - General Patton
"I'm very drunk and I intend on getting still drunker before this evening's over."
- Rhett Butler
A hammer, and a bolt that was just smaller than the outside diameter of the pin.
The strongest reason for the people to retain the right to keep and bear arms is,
as a last resort, to protect themselves against tyranny in government.
Thomas Jefferson
The actuator in my PT130 has died, and I cannot get the top pin out to remove the unit to save my life. I have broken punches, bolts, and hammers, and I've used heat and penetrating oil. A sledgehammer doesn't move the pin a bit. I'm at my wit's end. The entire unit is collecting dust in the shed.
All that being said to say, good luck.
Bookmarks