How bout you buy the proper tool and I'll get it off of ya for $40 when you get done with it?
https://www.ebay.com/itm/YAMAHA-TILT...MAAMXQLQJRFRGL
How bout you buy the proper tool and I'll get it off of ya for $40 when you get done with it?
https://www.ebay.com/itm/YAMAHA-TILT...MAAMXQLQJRFRGL
[SIGPIC][/SIGPIC]
Delta in a nutshell: Breeding grounds + small wetlands + big blocks of grass cover + predator removal + nesting structures + enough money to do the job= plenty of ducks to keep everyone smiling!
"For those that will fight for it...FREEDOM...has a flavor the protected shall never know."
-L/Cpl Edwin L. "Tim" Craft
OR you can do what civil said and use these
3pcs-3-32-inch-steel-centre-punch-set-point.jpg
Jeweller-Ball-Peen-Hammer-2-oz-Forged-Steel-Head-and-with-a-Hardwood-Handle-21.jpg
Last edited by willyworm; 06-05-2018 at 01:02 PM. Reason: my fingers don't work
[SIGPIC][/SIGPIC]
Delta in a nutshell: Breeding grounds + small wetlands + big blocks of grass cover + predator removal + nesting structures + enough money to do the job= plenty of ducks to keep everyone smiling!
"For those that will fight for it...FREEDOM...has a flavor the protected shall never know."
-L/Cpl Edwin L. "Tim" Craft
Have the same motor and have been through the same thing. If you boat in salt water the eBay wrench isn’t going to cut it. I broke all the pins off before I even got going good and that was after several kroil baths and heat. Either buy the Yamaha tool for $100 plus or get new caps with the seals and beat the old ones off with a punch. Even the Yamaha wrench will break sometimes.
It took a 30ton press to remove stainless shaft from the bracket assembly but a 5lb hammer and punch removed the damn cap off the trim unit. Saltwater is hell!
You got to put the oil back in it.
"I'm just a victim of a circumstance"
Freshwater boat all the way. Guess I'll try the punches. Watched one video where they cut a notch in the top of the cap with a hacksaw blade and used a flat blade to punch it around. I'll get it one way or the other. Just trying to avoid making it look like shit or having to buy more shit.
I made this one, use grade 8’s and they won’t break
You can use a pipe wrench to get the cap off if you plan to use a new cap
Last edited by Gone South; 06-05-2018 at 05:53 PM.
The diameter of the pins that fit into the top of the cap is 0.158". What did you fit those bolts into?
[SIGPIC][/SIGPIC]
Delta in a nutshell: Breeding grounds + small wetlands + big blocks of grass cover + predator removal + nesting structures + enough money to do the job= plenty of ducks to keep everyone smiling!
"For those that will fight for it...FREEDOM...has a flavor the protected shall never know."
-L/Cpl Edwin L. "Tim" Craft
Bookmarks